2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

SWITCHES LOCATION

Component Location
A/C Pressure Switch (2.5L) (B10) On A/C receiver-drier. See Figure.
Back-Up Light Switch (Turbo) (T13) On transmission. See Figure.
Back-Up Light Switch (2.5L) (B24) On transfer case. See Figure.
Brake Fluid Level Switch (2.5L) (B16) In brake master cylinder. See Figure.
Buckle Switch (AB51) In seat belt buckle. See Figure.
Front Door Switch LH (Sedan) (R9) On left "B" pillar. See Figure.
Front Door Switch LH (Wagon) (R9) On left "B" pillar. See Figure.
Front Door Switch RH (Sedan) (R12) On right "B" pillar. See Figure.
Front Door Switch RH (Wagon) (R12) On right "A" pillar. See Figure.
Front Seat Belt Switch (Sedan) (R8) In respective seat belt assembly. See Figure.
Front Seat Belt Switch (Wagon) (R8) In respective seat belt assembly. See Figure.
Hood Switch (B321) Right side on engine compartment. See Figure.
Inhibitor Switch (2.5L Non-Turbo) (T7) Top of transmission. See Figure.
Neutral Position Switch (Turbo MT) (T12) On transmission. See Figure.
Oil Pressure Switch (2.5L, Non-Turbo) (E11) Upper front center of engine. See Figure.
Oil Pressure Switch (2.5L Turbo) (E11) Upper front center of engine. See Figure.
Oil Pressure Switch (3.0L) (E11) On right front of engine. See Figure.
Parking Switch (B69) Center of dash. See Figure.
Parking Brake Switch (Wagon) (R4) On parking brake assembly. See Figure.
Power Steering Oil Pressure Switch (2.5L Non-Turbo) (E19) On power steering oil pump. See Figure.
Power Steering Oil Pressure Switch (2.5L Turbo) (E19) On power steering oil pump. See Figure.
Power Steering Oil Pressure Switch (3.0L) (E19) On power steering oil pump. See Figure.
Rear Door Switch LH (Sedan) (R22) On left "C" pillar. See Figure.
Rear Door Switch LH (Wagon) (R22) On left "C" pillar. See Figure.
Rear Door Switch RH (Sedan) (R16) On right "C" pillar. See Figure.
Rear Door Switch RH (Wagon) (R16) On right "C" pillar. See Figure.
Rear Gate Latch Switch (Wagon) (D46) Bottom center of rear gate. See Figure.
Stop & Brake Switch (B65) On brake pedal bracket. See Figure.
Variable Valve Lift Diagnosis Oil Pressure Switch LH (2.5L Non-Turbo) (E72) Rear of left cylinder head. See Figure.
Variable Valve Lift Diagnosis Oil Pressure Switch LH (3.0L) (E72) Left rear of engine. See Figure.
Variable Valve Lift Diagnosis Oil Pressure Switch RH (2.5L Non-Turbo) (E71) Rear of right cylinder head. See Figure.
Variable Valve Lift Diagnosis Oil Pressure Switch RH (3.0L) (E71) Right rear of engine. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.