2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

VDC Control Module and Hydraulic Control Unit (VDCCM&H/U): Installation

  1. Install the VDCCM&H/U bracket.

    Tightening torque: 

    33 N.m (3.4 kgf-m, 24 ft-lb) 

  2. Install the VDCCM&H/U with a new nut (Part No. 023506000) by aligning the damper groove of the VDCCM&H/U to the bracket side claw.

    Tightening torque: 

    7.5 N.m (0.76 kgf-m, 5.5 ft-lb) 

    Fig 1: Locating Nuts On VDCCM&H/U
    G05343419Courtesy of SUBARU OF AMERICA, INC.
  3. Connect the brake pipes to their correct VDCCM&H/U positions.

    Tightening torque: 

    T1: 15 N.m (1.5 kgf-m, 11.1 ft-lb) 

    T2:19 N.m (1.9 kgf-m, 14 ft-lb) 

    Fig 2: Connecting Brake Pipes To VDCCM&H/U
    G05343421Courtesy of SUBARU OF AMERICA, INC.
  4. Connect the VDCCM&H/U connector.
    NOTE:
    • Be sure to remove all foreign matter from inside the connector before connecting.
    • Make sure the VDCCM&H/U connector is securely locked.
  5. Bleed air from the brake system.
  6. Check the parameter to confirm that the applied models and grades of the relevant vehicle are included. <Ref. to PARAMETER CHECK , OPERATION, Subaru Select Monitor .>
  7. If the applied model and grade of the target vehicle are not included on the {Parameter Check} display screen, perform parameter selection and registration. <Ref. to PARAMETER SELECTION , OPERATION, Subaru Select Monitor .>
    NOTE:
    • When the VDCCM&H/U is replaced with a new part, be sure to perform the selection registration operation.
    • For the selection and registration of parameter, the Subaru Select Monitor III is required.
    • When no data is registered, ABS/EBD/VDC warning light illuminates and the DTC "Parameter selection failure" is detected.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.