Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Wiper Deicer System: Inspection
INSPECTION CHART
| Symptom | Repair order |
|---|---|
| Wiper deicer does not operate. |
|
Refer to "REAR WINDOW DEFOGGER " for inspection.
< Ref. to INSPECTION , Rear Window Defogger. >
NOTE:
Wiper deicer system can be customized on the Subaru Select Monitor.
INSPECTION CHART
| System name | Initial setting | Customize setting | ||
|---|---|---|---|---|
| Wiper deicer timer | OFF after 15 min. | Continuous operation(1) | ||
|
||||
- Ambient temperature at 5°C (41°F) or more continues for 10 sec.
- Malfunction occurs on ambient sensor.
- Vehicle speed below 15 km/h (9 MPH) continues 15 min.
- Malfunction occurs in CAN communication.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.