Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Using Windshield Glass Knife

Remove the cowl panel.
< Ref. to REMOVAL , Cowl Panel. >
Remove the molding.
Tape the body side of the circumference of windshield glass for protection.
Apply sufficient amount of soapy water to the adhesive part.
Insert the windshield glass knife into the adhesive.
While holding the knife edge and windshield glass edge at a right angle, move the windshield glass knife parallel to the windshield glass edge along the surface and edge of windshield glass to cut the adhesive.
NOTE:
- Do not twist the windshield glass knife.
- Cutting of adhesive part shall be started with wider gap between windshield glass and body.
  
  Fig 1: Identifying Gap Between Windshield Glass And Body
  Courtesy of SUBARU OF AMERICA, INC.
- The locating pins are bonded to the corners of glass. Use piano wire to disconnect the pins.
  
  Fig 2: Identifying Locating Pins Bonded To Corners Of Glass
  Courtesy of SUBARU OF AMERICA, INC.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.