Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2008 Subaru Legacy R LimitedFACTORY OEM SERVICE PROCEDURE

EGR Valve: Removal

Remove the collector cover and the engine side cover.
Disconnect the ground cable from the battery.

Fig 1: Disconnecting Ground Cable From Battery
Courtesy of SUBARU OF AMERICA, INC.
Remove the air intake chamber. < Ref. to REMOVAL , Air Intake Chamber. >
Remove the starter. < Ref. to REMOVAL . >
Remove the EGR pipe from the EGR valve and the cylinder head.
Remove the EGR valve from intake manifold.

Fig 2: Identifying EGR Valve From Intake Manifold
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the connector from the EGR valve.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.