Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Subaru Legacy GT spec.BFACTORY OEM SERVICE PROCEDURE
SI-DRIVE Selector: Inspection
Measure the resistance between SI-DRIVE selector terminals.
RESISTANCE SPECIFICATION
| Switch position | Terminal No. | Standard |
|---|---|---|
| Sport (when turning the SI-DRIVE selector to the left) | 2 and 3 | Less than 10 Ξ© |
| Intelligent (when pushing the SI-DRIVE selector) | 0.8 - 1.2 kΞ© | |
| Sport Sharp (when turning the SI-DRIVE selector to the right) | 2.14 - 3.2 kΞ© |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.