Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Subaru Legacy GT spec.BFACTORY OEM SERVICE PROCEDURE
Oil Flow Control Solenoid Valve: Assembly
- Install the oil flow control solenoid valve.
Tightening torque:Â
8 N.m (0.8 kgf-m, 5.9 ft-lb)Â
- Apply liquid gasket to the two bolts which secure the oil return cover.
Liquid gasket:Â
THREE BOND 1324 (Part No. 004403042) or equivalentÂ
- Attach the oil return cover and gasket.
Tightening torque:Â
8 N.m (0.8 kgf-m, 5.9 ft-lb)Â
NOTE: Use a new gasket.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.