Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Subaru Outback i, StandardFACTORY OEM SERVICE PROCEDURE
General Information: Specifications: Legacy: Transmission
TRANSMISSION DATA SPECIFICATION
| Model | 2.5 L SOHC | 2.5 L DOHC turbo | |||||
| Transmission type | 5MT | 4AT | 5MT | 5AT | 6MT | ||
| Clutch type | DSPD | TCC | DSPD | TCC | DSPD | ||
| Gear ratio | 1st | 3.454 | 2.785 | 3.166 | 3.540 | 3.636 | |
| 2nd | 2.062 | 1.545 | 1.882 | 2.264 | 2.235 | ||
| 3rd | 1.448 | 1.000 | 1.296 | 1.471 | 1.521 | ||
| 4th | 1.088 | 0.694 | 0.972 | 1.000 | 1.137 | ||
| 5th | 0.780 | - | 0.738 | 0.834 | 0.891 | ||
| 6th | - | - | - | - | 0.707 | ||
| Rev. | 3.333 | 2.272 | 3.333 | 2.370 | 3.545 | ||
| Reduction gear (Front) | 1st reduction | Type of gear | - | Helical | - | Helical | - |
| Gear ratio | - | 1.000 | - | 1.000 | - | ||
| Final reduction | Type of gear | Hypoid | Hypoid | Hypoid | Hypoid | Hypoid | |
| Gear ratio | 3.900 | 4.111 | 3.900 | 3.083 | 3.900 | ||
| Reduction gear (Rear) | Transfer reduction | Type of gear | Helical | - | Helical | - | Helical |
| Gear ratio | 1.000 | - | 1.000 | - | 1.100 | ||
| Final reduction | Type of gear | Hypoid | Hypoid | Hypoid | Hypoid | Hypoid | |
| Gear ratio | 3.900 | 4.111 | 3.900 | 3.083 | 3.545 | ||
| 5MT: 5-forward speeds with synchromesh and 1-reverse 4AT: Electronically controlled fully-automatic, 4-forward speeds and 1-reverse 5AT: Electronically controlled fully-automatic, 5-forward speeds and 1 -reverse DSPD: Dry Single Plate Diaphragm TCC: Torque Converter Clutch |
|||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.