Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Subaru Outback i, AutomaticFACTORY OEM SERVICE PROCEDURE
Reverse Check Cable: Adjustment
- Set the vehicle on a lift.
- Remove the under cover.
- Remove the rear exhaust pipe and muffler. <Ref. to REMOVAL , Rear Exhaust Pipe .> <Ref. to REMOVAL , Muffler .>
- Remove the crossmember. <Ref. to REMOVAL , Transmission Mounting System .>
- Remove the snap pin and washer, and separate the reverse check cable from the reverse check lever.
- Move the transmission to the right side, and remove the stay bolts and reverse check cable.NOTE: If the transmission is not moved aside, the stay bolts may contact the body and cause damage.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.