2007 Subaru Outback i, AutomaticFACTORY OEM SERVICE PROCEDURE

5MT Model

  1. Install the joint to the transmission and secure with a spring pin.
  2. Insert the gear shift lever from the room side.
    NOTE: Insert the rod and the stay, and then temporarily set them onto the transmission mount.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.