Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Subaru Outback i, AutomaticFACTORY OEM SERVICE PROCEDURE
AT Steering Shift Switch: Removal
- Disconnect the ground cable from the battery.
- Set the tire to the straight-ahead position.
- Remove the airbag module. <Ref. to
REMOVAL
, Driver's Airbag Module .>WARNING: If airbag modules are mounted, always refer to "Airbag System" when performing airbag module service. <Ref. to INSPECTION , Driver's Airbag Module .>
- Remove the steering wheel. <Ref. to REMOVAL , Steering Wheel .>
- Remove the cover from steering wheel.
- Remove the AT steering shift switch mounting screws from the left and right side, one on each side.
- Remove the steering shift switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.