Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Subaru Outback i, AutomaticFACTORY OEM SERVICE PROCEDURE
Explanation Of Terminology
ListÂ
EXPLANATION OF TERMINOLOGY LIST
| AAI | Air Assist Injection |
| A/B | Airbag |
| ABS | Anti-lock Brake System |
| A/C | Air Conditioner |
| A/F | Air Fuel Ratio |
| ALT | Generator |
| ASSY | Assembly |
| AT | Automatic Transmission |
| ATF | Automatic Transmission Fluid |
| BATT | Battery |
| CD-R/RW | CD Recordable/Rewritable |
| CPU | Central Processing Unit |
| DOHC | Double Overhead Camshaft |
| DVD | Digital Versatile Disc |
| ECM | Engine Control Module |
| EGR | Exhaust Gas Recirculation |
| ELR | Emergency Locking Retractor |
| EX | Exhaust |
| F/B | Fuse & Joint Box |
| FL | Fusible Link |
| Ft | Full-time (AWD) |
| FWD | Front Wheel Drive |
| GPS | Global Positioning System |
| H/U | Hydraulic Unit |
| IG | Ignition |
| INT | Intermittent |
| ISC | Idle Speed Control |
| LH | LH (Left Hand) |
| LSD | Limited Slip Differential |
| M/B | Main Fuse & Relay Box |
| MD | Mini Disc |
| MFI | Multi Point Injection |
| MID | Multi Information Display |
| MP-T | Multi-Plate Transfer |
| MT | Manual Transmission |
| NA | Natural Aspiration |
| NC | Normal Close (Relay) |
| NO | Normal Open (Relay) |
| OP | Option Parts |
| P/S | Power Steering |
| P/W | Power Window |
| PCD | Pitch Circle Diameter |
| PCV | Positive Crankcase Ventilation |
| RH | RH (Right Hand) |
| Rr | Rear |
| SOHC | Single Overhead Camshaft |
| SRS | Supplemental Restraint System |
| SSM | Subaru Select Monitor |
| ST | Special Tool |
| SW | Switch |
| TCS | Traction Control System |
| TGV | Tumble Generator Valve |
| T/M | Transmission |
| ViS-C | Viscous Coupling |
| VSV | Vacuum Switching Valve |
| VTD | Variable Torque Distribution |
| W/H | Wiring Harness |
| Pr | Primary |
| 2ndr | Secondary |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
