2007 Subaru Outback i, AutomaticFACTORY OEM SERVICE PROCEDURE

ABS Control Module and Hydraulic Control Unit (ABSCM&H/U): Replacement

CAUTION:
  • Because the seal of the ABSCM cannot be replaced, do not pull or peel it by lifting it up.
  • Because the screw of the H/U will become slightly worn in every replacement procedure, 5 times is the maximum number of times for replacement. If a problem is found such as not being able to torque the screw to specifications even before 5 replacement operations are performed, replace the H/U body.
  • When installing the ABSCM, always use new screws.
  • When the sealing surface of the ABSCM or H/U is dirty or damaged and it cannot be removed or repaired, replace with a new part.
  1. Remove the ABSCM&H/U bracket. < Ref. to REMOVALΒ , ABS Control Module and Hydraulic Control Unit (ABSCM&H/U). >
  2. To prevent entry of foreign objects and brake fluid leakage, plug the oil pressure port of the ABSCM&H/U using a screw plug, etc.
  3. Set the pump motor section of the removed ABSCM&H/U face down on a vise.
    NOTE: Before securing a part in a vise, place cushioning material such as wood blocks, aluminum plate or cloth between the part and the vise.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.