2007 Subaru Outback i, AutomaticFACTORY OEM SERVICE PROCEDURE

ABS Control Module and Hydraulic Control Unit (ABSCM&H/U): Installation

  1. Install the ABSCM&H/U bracket.

    Tightening torque: 

    33 N.m (3.3 kgf-m, 24 ft-lb) 

  2. Install the ABSCM&H/U by aligning the damper groove of the ABSCM&H/U to the bracket side claw.
    NOTE: Check the identification marks of the ABSCM&H/U.

    Tightening torque: 

    7.5 N.m (0.76 kgf-m, 5.5 ft-lb) 

    Fig 1: Locating ABSCM&H/U Nuts
    G05020203Courtesy of SUBARU OF AMERICA, INC.
  3. Connect the brake pipes to their correct ABSCM&H/U positions.

    Tightening torque: 

    15 N.m (1.5 kgf-m, 10.8 ft-lb) 

  4. Using a harness clip, secure the ABSCM&H/U harness to the bracket.
  5. Connect the connector to the ABSCM&H/U.
    NOTE:
    • Be sure to remove all foreign matter from inside the connector before connecting.
    • Make sure the ABSCU&H/U connector is securely locked.
  6. Bleed air from the brake system.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.