Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Method
- Exhaust gas temperature diagnosis
Abnormality Judgment
Calculate the estimated exhaust gas temperature when the diagnostic enable condition is established. Judge as NG when the following conditions are established in 14 seconds after starting the engine.
Judgment Value
| Malfunction Criteria | Threshold Value |
|---|---|
| Estimated exhaust gas temperature | < Value from Map 1 |
Map 1
| Engine coolant temperature at engine start | -40°C (-40°F | -30° (-22°F) | -20°C (-4°F) | -10°C (14°F) | 0°C (32°F) | 10°C (50°F) | 20°C (68°F) | 30°C (86°F) | 40°C (104°F) | 45°C (113°F) |
| Threshold Value | 200°C (392°F) | 200°C (392°F | 200°C (392°F | 200°C (392°F) | 97°C (207°F) | 97°C (207°F | 96°C (205°F | 92°C (198°F | 89°C (192°F) | 88°C (190°F) |
Time Needed for Diagnosis: 14 seconds
Malfunction Indicator Light Illumination: Illuminates when malfunction occurs in 2 continuous driving cycles. Normality Judgment
Judge as OK when the following conditions are established after the specified amount of time has passed.
Judgment Value
| Malfunction Criteria | Threshold Value |
|---|---|
| Estimated exhaust gas temperature | ≥ Value from Map 1 |
- Idle speed diagnosis
Judge as NG when all of the following conditions are established, and judge as OK when the following conditions are not met.
| Malfunction Criteria | Threshold Value |
|---|---|
| Continuous time of (Target engine speed - Actual engine speed > 100 rpm) | ≥ 6 seconds (AT) ≥ 5 seconds (MT) |
Time Needed for Diagnosis: 6 seconds
Malfunction Indicator Light Illumination: Illuminates when malfunction occurs in 2 continuous driving cycles.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
