Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Subaru Outback F6-3.0L DOHCFACTORY OEM SERVICE PROCEDURE
Connecting Rod, Engine
CONNECTING ROD
Thrust clearance, standard 0.070 - 0.330 mm (0.0028 - 0.0130 inch)
Oil clearance, standard 0.016 - 0.043 mm (0.0006 - 0.0017 inch)
Clearance between pin & bushing, standard 0 - 0.022 mm (0 - 0.0009 inch)
CONNECTING ROD BEARING
CONNECTING ROD BOLTS 53 N-m (5.4 kgf-m, 39 ft. lbs.)
Thrust clearance, standard 0.070 - 0.330 mm (0.0028 - 0.0130 inch)
Oil clearance, standard 0.016 - 0.043 mm (0.0006 - 0.0017 inch)
Clearance between pin & bushing, standard 0 - 0.022 mm (0 - 0.0009 inch)
CONNECTING ROD BEARING
Connecting rod oil clearance:
CONNECTING ROD BOLTS 53 N-m (5.4 kgf-m, 39 ft. lbs.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.