2007 Subaru Forester XT Limited, AutomaticFACTORY OEM SERVICE PROCEDURE

Mode $02 (Powertrain Freeze Frame Data)

Refer to data denoting the operating condition when trouble is detected by on-board diagnosis system. A list of the support data and PID (Parameter Identification) codes are shown in the following table.

POWERTRAIN FREEZE FRAME DATA

PID Data Unit of measure
02 DTC that caused CARB required freeze frame data storage -
03 Fuel system control status -
04 Calculated engine load value %
05 Engine coolant temperature °C
06 Short term fuel trim %
07 Long term fuel trim %
0B Intake manifold absolute pressure mmHg
0C Engine speed rpm
0D Vehicle speed km/h
0E Ignition timing advance °
0F Intake air temperature °C
10 Air flow rate from mass air flow sensor g/sec
11 Throttle valve absolute opening angle %
12 Secondary air control status -
13 Air fuel ratio sensor -
15 Oxygen sensor output voltage and oxygen sensor short term fuel trim V and %
1C Supporting OBD system -
1F Elapsed time after starting engine sec
2E Evaporative purge %
2F Fuel level %
32 Fuel tank pressure mmHg
33 Atmospheric pressure mmHg
42 ECM power voltage V
43 Absolute load %
44 A/F target lambda -
45 Relative throttle opening angle %
46 Ambient temperature °C
47 Absolute throttle opening angle 2 %
49 Absolute accelerator opening angle 1 %
4A Absolute accelerator opening angle 2 %
4C Target throttle opening angle %
NOTE: Refer to general scan tool manufacturer's instruction manual to access freeze frame data (MODE $02).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.