Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2007 Subaru Forester X, AutomaticFACTORY OEM SERVICE PROCEDURE

Select Cable: Removal

Set the vehicle on a lift.
Disconnect the ground cable from battery.
Prior to removal, set the lever to "N" range.
Lift-up the vehicle.
Remove the front and center exhaust pipes. Non-turbo model
<Ref. to REMOVAL Front Exhaust Pipe. >

Turbo model

<Ref. to REMOVAL Front Exhaust Pipe. >
Remove the heat shield cover. (If equipped)
Remove the snap ring from the range select lever.

Fig 1: Identifying Snap Ring And Range Select Lever
Courtesy of SUBARU OF AMERICA, INC.
Remove the plate assembly from the transmission case.

Fig 2: Identifying Plate Assembly
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the select cable from select lever and then remove the cable bracket.

Fig 3: Identifying Select Cable From Select Lever
Courtesy of SUBARU OF AMERICA, INC.
Remove the select cable from plate assembly.

Chapter Navigation

Return to Chapter: Select Cable

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.