Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2007 Subaru Forester X, AutomaticFACTORY OEM SERVICE PROCEDURE

Select Cable: Installation

Install the select cable to plate assembly.
Tightening torque:

18 N.m (1.8 kgf-m, 13.0 ft-lb)
Install the select cable to select lever.
Install the plate assembly to the transmission.
Tightening torque:

T: 24.5 N.m (2.5 kgf-m, 18.1 ft-lb)

Fig 1: Identifying Select Cable And Select Lever
Courtesy of SUBARU OF AMERICA, INC.
Install the washer and snap pin to range select lever.

Fig 2: Identifying Washer And Snap Pin
Courtesy of SUBARU OF AMERICA, INC.
Move the select lever to the "N" range, then adjust the select cable position. <Ref. to ADJUSTMENT Select Cable. >
Install the heat shield cover. (If equipped)
Install the front and center exhaust pipe. Non-turbo model
<Ref. to INSTALLATION Front Exhaust Pipe. >

Turbo model

<Ref. to INSTALLATION Front Exhaust Pipe. >

Chapter Navigation

Return to Chapter: Select Cable

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.