2007 Subaru Forester X, AutomaticFACTORY OEM SERVICE PROCEDURE

For CANADA Model

MAINTENANCE SCHEDULE 1 (CANADA)

  MAINTENANCE INTERVAL [Number of months or km (miles), whichever occurs first]
  Months 3 7.5 15 22.5 30 37.5 45 52.5 60 67.5 75 82.5 90 97.5 105 112.5 120 Remarks
x 1,000 km 4.8 12 24 36 48 60 72 81.4 96 108 120 132 144 156 168 180 192
x 1,000 miles 3 7.5 15 22.5 30 37.5 45 52.5 60 67.5 75 82.5 90 97.5 105 112.5 120
1 Engine oil R R R R R R R R R R R R R R R R R  
2 Engine oil filter R R R R R R R R R R R R R R R R R  
3 Spark plug         R       R       R       R Non-turbo Model
                R               R Turbo Model
4 Drive belt         I       I       I   R      
5 Timing belt         I       I       I   R      
6 Fuel line         (I)       (I)       (I)       I (1)
7 Fuel filter                 R               R (1)
8 Air cleaner element         R       R       R       R (2)
9 Cooling system         I       I       I       I  
10 Engine coolant         R       R       R       R  
11 Clutch system     I   I   I   I   I   I   I   I  
12 Transmission oil         I       I       I       I  
13 ATF         I       I       I       I  
14 Front & rear differential gear oil         I       I       I       I  
15 Brake line     I   I   I   I   I   I   I   I  
16 Brake fluid         R       R       R       R  
17 Disc brake pads and discs         I       I       I       I  
18 Brake linings and drums         I       I       I       I  
19 Parking brake     I   I   I   I   I   I   I   I  
20 Suspension     I   I   I   I   I   I   I   I  
21 Wheel bearing                 (I)               (I)  
22 Axle boots and joints     I   I   I   I   I   I   I   I  
23 Tire rotation   I I I I I I I I I I I I I I I I (4)
24 Steering system (Power steering)     I   I   I   I   I   I   I   I  
25 Airbag system 10th-year inspection  
26 ATF filter assembly Annual inspection (3)
27 Air conditioner filter Every 12 months or 12,000 km (7,500 miles) inspection  
Symbol
R: Replace
I: Inspect
(R) or (I): Inspections recommended for vehicle safety
(1) This inspection is not necessary to observe exhaust gas regulations or is the responsibility of the manufacturer under the current basic EPA regulations that must observed by law.
(2) Replace the air cleaner element more frequently than the periodic replacement if the vehicle is being used in an excessively dusty environment.
(3) The ATF filter needs replacement when it is physically damaged, rusty or ATF leaked.
(4) Replace the tires if the tread-wear indicator has cause a bar-shaped cut across the tread. The indicator will appear when the remaining amount of tread is less than 1.6 (0.063 in).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.