Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Subaru Forester X, AutomaticFACTORY OEM SERVICE PROCEDURE
Intake Manifold: Removal
- Release the fuel pressure.
<Ref. to RELEASING OF FUEL PRESSURE , Procedure, Fuel . >
- Disconnect the ground cable from the battery.
- Open the fuel filler flap lid, and remove the fuel filler cap.
- Remove the air intake duct, air cleaner case and air intake chamber. <Ref. to REMOVAL , Air Intake Duct. > <Ref. to REMOVAL , Air Cleaner Case. > <Ref. to REMOVAL , Air Intake Chamber. >
- Remove the generator. <Ref. REMOVAL , Generator. >
- Remove the power steering pump and power steering reservoir tank.
- Remove the bolts which hold the power steering pipes onto the fuel pipe protector RH.NOTE: Do not disconnect the power steering hose.
- Remove the bolts which hold the power steering pipes onto the fuel pipe protector RH.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.