Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Subaru B9 Tribeca BaseFACTORY OEM SERVICE PROCEDURE
Select Lever: Assembly
- Clean all the parts before assembly.
- Apply grease [Multemp AC-D, and SH-W or equivalent] to each part. < Refer to AT SELECT LEVER , COMPONENT, GENERAL DESCRIPTION. >
- Assemble in the reverse order of disassembly.NOTE:
- Refer to "COMPONENT " for each tightening torque. < Refer to AT SELECT LEVER , COMPONENT, GENERAL DESCRIPTION. >
- When pressing in the shift position pin, insert from the left side of the vehicle.
- Affix the harness of the shift button switch and the mode change switch at the marked positions.
- Connect the terminals of all switches to the respective connectors.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.