Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Subaru B9 Tribeca BaseFACTORY OEM SERVICE PROCEDURE
Select Cable: Installation
- Install the select cable to plate assembly.
Tightening torque:
T: 18 N.m (1.8 kgf-m, 13.3 ft-lb)
- Install the select cable to range select lever.
- Install the plate assembly to transmission.
Tightening torque:
24.5 N.m (2.5 kgf-m, 18.1 ft-lb)
- Install the washer and snap pin to range select lever.
- Install new clamp paying attention to the installing direction shown in illustration.
- Insert the tip of inner cable into connector hole of select lever, and fix the cable to bracket.
- Shift the select lever to the "N" range, and then adjust the select cable position. < Refer to ADJUSTMENT , SELECT CABLE. >
- Install the heat shield cover.
- Install the front, center and rear exhaust pipe, and the muffler. < Refer to INSTALLATION , Front Exhaust Pipe. > < Refer to INSTALLATION , Rear Exhaust Pipe. > < Refer to INSTALLATION , Muffler. >
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.