Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Subaru B9 Tribeca BaseFACTORY OEM SERVICE PROCEDURE
Injector Control. (Injection Stop Mode)
- On the «System Operation Check Mode» display screen, select {Injector Control}.
- On the «Injector Control» display screen, select {Injection Stop Mode}.
- Start the engine on the desired injector number in the «Injection Stop Mode» screen, and select the [OK].
- On the «Start the Engine» display screen, start the engine and select the [OK].
- Select the [NO] to end the injection stop mode. The screen will return to the «Injector Control» screen.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.