Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Subaru B9 Tribeca BaseFACTORY OEM SERVICE PROCEDURE
Drive Cycle E
- Check that the battery voltage is over 10.9 V.
- Perform the Clear Memory Mode. <Ref. to CLEAR MEMORY MODE . >
- Drive for approximately 30 l
(7.9 US gal, 6.6 Imp gal) of fuel.NOTE:
- It is acceptable to drive the vehicle intermittently.
- Do not disconnect the battery terminals while diagnosing. (Data will be cleared by disconnecting the battery terminals.)
DTC CHARTDTC Item On condition P0461 Fuel Level Sensor Circuit Range/Performance -
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.