Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Subaru B9 Tribeca BaseFACTORY OEM SERVICE PROCEDURE
RH Side
- Remove the collector cover.
- Release the fuel pressure. <Ref. to RELEASING OF FUEL PRESSURE , Procedure, Fuel .>
- Disconnect the ground cable from the battery.
- Open the fuel filler flap lid, and remove the fuel filler cap.
- Remove the air cleaner case. <Ref. to REMOVAL , Air Cleaner Case .>
- Remove the fuel pipe protector RH.
- Disconnect the connector from fuel injector.
- Remove the engine harness from the fuel injector pipe RH.
- Remove the bolt which holds fuel injector pipe onto intake manifold.
- Remove the fuel injector while lifting up the fuel injector pipe.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.