2007 Subaru B9 Tribeca BaseFACTORY OEM SERVICE PROCEDURE

Transmission Control Module (TCM): Installation

  1. Install the relay to TCM body.
  2. Install the TCM.

    Tightening torque:Β 

    7.5 N.m (0.76 kgf-m, 5.5 ft-lb)Β 

    Fig 1: Identifying Transmission Control Module And Steering Column
    G05346447Courtesy of SUBARU OF AMERICA, INC.
  3. Connect the connector to the TCM.
  4. Install in the reverse order of removal.
  5. Perform Clear Memory 2 operation. <Ref. to CLEAR MEMORY MODE , Operation, Subaru Select Monitor .>
  6. Perform the inspection with driving the vehicle at the end of repair work, and make sure there is no faulty as below;
    • Excessive shift shock
    • Oil leakage from the transmission body, etc.
    • Occurrence of noise caused by interference etc.
    NOTE: If excessive shift shock is felt, execute advance operation of learning control. <Ref. to PROCEDURE , Learning Control .>
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.