2007 Subaru B9 Tribeca BaseFACTORY OEM SERVICE PROCEDURE

Converter Case: Removal

  1. Remove the transmission assembly from vehicle body. <Ref. to REMOVAL , Automatic Transmission Assembly .>
  2. Remove the torque converter assembly. <Ref. to REMOVAL , Torque Converter Assembly .>
  3. Remove the transmission harness connector from stay.
  4. Remove the turbine speed sensor 1. <Ref. to REMOVAL , Turbine Speed Sensor 1 .>
  5. Remove the oil charge pipe. <Ref. to REMOVAL , Oil Charge Pipe .>
  6. Remove the ATF filter inlet and outlet pipes. <Ref. to REMOVAL , ATF Cooler Pipe and Hose .>
  7. Remove the converter case attachment bolts.
  8. Lay along the transmission body, and then remove the oil pan.
  9. Remove the three converter case mounting bolts (TORX®).

    ST 18676AA020 TORX® WRENCH

    Fig 1: Identifying Converter Case Mounting Bolts
    G05022333Courtesy of SUBARU OF AMERICA, INC.
  10. Separate the converter case by lightly tapping with plastic hammer.
  11. Remove the differential assembly. <Ref. to REMOVAL , Front Differential Assembly .>
  12. Remove the oil seal from converter case.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.