Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Converter Case: Installation
- Check the appearance of each component and clean them.
- Press-fit the oil seal to converter case using ST.
ST 499587100 OIL SEAL INSTALLER
- Install the differential assembly to the case. <Ref. to INSTALLATION , Front Differential Assembly .>
- Install the right and left side retainers. <Ref. to ADJUSTMENT , Front Differential Assembly .>
- Apply proper amount of liquid gasket to the entire matching surface of converter case.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007)
- Install the converter case assembly without damaging bushing and oil seal.
Tightening torque:
41 N.m (4.2 kgf-m, 30.4 ft-lb)
- Install the three converter case mounting bolts (TORX®).
ST 18676AA020 TORX® WRENCH
Tightening torque:
41 N.m (4.2 kgf-m, 30.4 ft-lb)
- Apply proper amount of liquid gasket to the entire oil pan mating surface, and then install it.
Liquid gasket:
THREE BOND 1217B (Part No. K0877YA020)
Tightening torque:
5 N.m (0.5 kgf-m, 3.7 ft-lb)
- Install the transmission harness connector to the stay.
- Install the air breather hose. <Ref. to INSTALLATION , Air Breather Hose .>
- Install the ATF filter pipe. <Ref. to INSTALLATION , ATF Cooler Pipe and Hose .>
- Install the oil charge pipe with O-ring. <Ref. to INSTALLATION , Oil Charge Pipe .>
- Install the torque converter assembly. <Ref. to INSTALLATION , Torque Converter Assembly .>
- Install the transmission assembly to the vehicle, <Ref. to INSTALLATION , Automatic Transmission Assembly .>
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
