Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Subaru Outback XT, StandardFACTORY OEM SERVICE PROCEDURE
SUBARU Select Monitor
- After clearing the memory, check for any remaining unresolved trouble data.
< Ref. to CLEAR MEMORY MODE . >
- Warm-up the engine.
- Prepare the Subaru Select Monitor kit. < Ref. to PREPARATION TOOL , General Description. >
- Connect the diagnosis cable to the Subaru Select Monitor.
- Insert the cartridge to the Subaru Select Monitor. < Ref. to PREPARATION TOOL , General Description. >
- Connect the test mode connector (A) located under the glove box.
- Connect the Subaru Select Monitor to data link connector located in the lower portion of the instrument panel (on the driver's side).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.