Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Subaru Outback XT, StandardFACTORY OEM SERVICE PROCEDURE
Remote Control Mirror Switch
Move the remote control mirror switch to each position and check continuity between terminals.
- Change over switch RRESISTANCE SPECIFICATION CHART
Switch position Terminal No. Standard OFF - 1 M Ω or more UP 10 and 12, 15 and 14 Less than 1 Ω DOWN 10 and 15, 12 and 14 Less than 1 Ω LEFT 10 and 11, 15 and 14 Less than 1 Ω RIGHT 10 and 15, 11 and 14 Less than 1 Ω - Change over switch LRESISTANCE SPECIFICATION CHART
Switch position Terminal No. Standard OFF - 1 MΩ or more UP 10 and 8, 15 and 14 Less than 1 Ω DOWN 10 and 15, 8 and 14 Less than 1 Ω LEFT 10 and 9, 15 and 14 Less than 1 Ω RIGHT 10 and 15, 9 and 14 Less than 1 Ω Replace the remote control mirror switch if defective.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.