Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Subaru Outback XT, AutomaticFACTORY OEM SERVICE PROCEDURE
Transmission Control Device: Removal
- Remove the transmission assembly from vehicle body. < Ref. to REMOVAL , Automatic Transmission Assembly. >
- Pull out the torque converter assembly. < Ref. to REMOVAL , Torque Converter Assembly. >
- Lift-up the lever on the rear side of transmission harness connector, and then disconnect it from the stay.
- Disconnect the air breather hose. < Ref. to REMOVAL , Air Breather Hose. >
- Wrap vinyl tape around the nipple attached to the air breather hose.
- Remove the pitching stopper bracket.
- Remove the control valve body assembly. < Ref. to REMOVAL , Control Valve Body. >
- Pull out the straight pin of manual plate.
- Remove the bolts securing select lever, and then remove the select lever, manual plate and parking rod.NOTE: Be careful not to damage the lips of press-fitted oil seal in the case.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.