2006 Subaru Outback XT Limited, AutomaticFACTORY OEM SERVICE PROCEDURE

RH Side

  1. Release the fuel pressure.

    < Ref. to RELEASING OF FUEL PRESSUREΒ , PROCEDURE, Fuel. >

  2. Open the fuel filler flap lid, and remove the fuel filler cap.
  3. Remove the collector cover.
  4. Disconnect the ground cable from battery.
    Fig 1: Removing Collector Cover
    G05019586
  5. Remove the coolant filler tank. < Ref. to REMOVAL , Coolant Filler Tank. >
  6. Disconnect the connector from fuel injector.
  7. Remove the screw, then remove the fuel injector.
    Fig 2: Locating Fuel Injector Screw
    G05017814
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.