2006 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Select Lever: Removal

  1. Set the vehicle on a lift.
  2. Disconnect the ground cable from battery.
  3. Shift the select lever to "N" range.
  4. Lift up the vehicle.
  5. Remove the rear exhaust pipe and muffler.
    • SOHC model

      < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >

    • DOHC turbo model

      < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >

    • DOHC 3.0 L model

      < Ref. to REMOVAL , Rear Exhaust Pipe. > < Ref. to REMOVAL , Muffler. >

  6. Remove the heat shield cover.
    Fig 1: Identifying Heat Shield Cover
    G05019661
  7. Remove the cable from arm assembly.
    Fig 2: Identifying Cable
    G05019662
  8. Raise the pawl of clamp to remove the cable.
    Fig 3: Identifying Pawl Of Clamp
    G05019663
  9. Lower the vehicle.
  10. Remove the console box. < Ref. to REMOVAL , Console Box. >
  11. Remove the center console. < Ref. to REMOVAL , Center Console. >
  12. Remove the harness clips from the bracket.
    Fig 4: Identifying Harness Clips
    G05019664
  13. Disconnect the connectors, and then remove the four bolts to take out the select lever assembly from vehicle body.
    Fig 5: Locating Select Lever Assembly Bolts
    G05019665
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.