2006 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Front Differential Assembly: Removal

  1. Remove the transmission assembly from vehicle body. < Ref. to REMOVAL , Automatic Transmission Assembly. >
  2. Pull out the torque converter assembly. < Ref. to REMOVAL , Torque Converter Assembly. >
  3. Remove the transmission harness connector from stay.
  4. Remove the oil charge pipe. < Ref. to REMOVAL , Oil Charge Pipe. >
  5. Remove the ATF filter inlet and outlet pipes. < Ref. to REMOVAL , ATF Filter. >
  6. Separate the converter case from the transmission case. < Ref. to REMOVAL , Converter Case. >
  7. Remove the differential side retainers using ST.
    NOTE: Hold the differential case assembly by hand to avoid damaging the retainer mounting hole of the converter case.

    ST 18630AA010 WRENCH COMPL RETAINER

  8. Remove the differential assembly while being careful not to damage the attachment part of retainer.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.