2006 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Front Differential Assembly: Adjustment

  1. Using the ST, screw-in the retainer until resistance is felt.
    NOTE: Screw-in the RH side slightly deeper than the LH side.

    ST 18630AA010 WRENCH ASSY

    Fig 1: Identifying Wrench Assembly
    G05002728
  2. Remove the oil pump cover.
  3. Remove the liquid gasket from the mating surface completely.
  4. Install the oil pump cover to converter case, and secure them with tightening four bolts evenly.
    NOTE: Use an old gasket or aluminum washer to prevent damaging the mating surface of the housing.

    Tightening torque:Β 

    41 N.m (4.2 kgf-m, 30.4 ft-lb)Β 

  5. Rotate the drive pinion ten times or more using ST1 and ST2.

    ST1 18667AA010 HOLDER

    ST2 499787700 WRENCH

    Fig 2: Rotating Drive Pinion ST1 And ST2
    G05022361
  6. Tighten the LH retainer by rotating the shaft until resistance is felt. Then loosen the retainer RH. Keep tightening the retainer LH, and loosening the retainer RH until the pinion shaft no longer be turned. This is the "zero" state.
    Fig 3: Identifying Retainer
    G05022389
  7. After the "zero" state is established, back off the retainer LH 3 notches and secure it with the lock plate. Then back off the retainer RH and retighten until it stops. Rotate the drive pinion 2 or 3 times. Tighten the retainer RH further 1-3/4 notches. This sets the preload. Finally, secure the retainer with its lock plate.
    Fig 4: Identifying Lock Plate
    G05022390
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.