2006 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Front Strut: Removal

  1. Lift-up the vehicle, and then remove the front wheels.
  2. Scribe an alignment mark on the camber adjusting bolt and strut.
  3. Remove the bolt securing brake hose from strut.
    Fig 1: Removing Bolt Securing Brake Hose From Strut
    G03832304Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the bolt securing ABS wheel speed sensor harness.
    Fig 2: Removing Bolt Securing ABS Wheel Speed Sensor Harness
    G03832305Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the two bolts securing housing to strut.
    NOTE: While holding the head of adjusting bolt, loosen the self-locking nut.
  6. Remove the three nuts securing strut mount to body.
Fig 3: Removing Nuts Securing Strut Mount To Body
G03832306Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.