2006 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Operating Cylinder: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install in the reverse order of removal.
    NOTE: Before installing the operating cylinder, apply grease (SUNLIGHT 2: Part No. 003602010) to the contact point of the release lever and operating cylinder.

    Tightening torque:Β 

    T1: 18 N.m (1.8 kgf-m, 13.0 ft-lb)Β 

    T2: 37 N.m (3.8 kgf-m, 27.5 ft-lb)Β 

    Fig 1: Identifying Clutch Hose And Operating Cylinder
    G05020129
  2. After bleeding air from the operating cylinder, ensure that the clutch operates properly.

    < Ref. to CLUTCH FLUID AIR BLEEDINGΒ . >

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.