2006 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Section 11 (Clutch System): General Description: Specification

WARNING: This page is about a different variant/trim than selected.
GENERAL SPECIFICATIONS

Model 2.5 L Non-turbo 2.5 L Turbo
Clutch cover Diaphragm set load N (kgf, lbf) 5688 (580, 1279) 8150 (831, 1832)
Clutch disc Facing material Woven
O.D. x I.D. x thickness mm (in) 225 x 150 x 3.5 (8.86 x 5.91 x 0.14) 240 x 155 x 3.2 (9.45 x 6.10 x 0.13)
Spline outer diameter mm (in) 25.2 (0.992)
Depth of rivet head mm (in) Standard 1.3-1.9(0.051 - 0.075)
Limit of sinking 0.3(0.012)
Deflection limit mm (in) 0.7 (0.027) at R = 110 (4.33) 1.0 (0.039) at R = 110 (4.33)
Clutch release lever ratio 1.6
Release bearing Grease-packed self-aligning
Clutch pedal Full stroke mm (in) 130 - 135(5.12 - 5.31)
Free play mm (in) 4 - 13(0.16 - 0.51)
Flywheel Type Conventional Dual mass
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.