2006 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Cruise Control Command Switch: Removal

WARNING: This page is about a different car, the 2006 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Before servicing, be sure to read the notes in the AB section for proper handling of the driver's airbag module. < Ref. to CAUTION , GENERAL DESCRIPTION. >
  1. Set front wheels in straight ahead position.
  2. Turn ignition switch OFF.
  3. Disconnect ground cable from battery and wait for at least 20 seconds before starting work.
  4. Using TORX® BIT T30 (Tamper resistant type), loosen two TORX® bolts which secure driver's air-bag module.
    Fig 1: Loosening Torx® Bolt
    G04991872Courtesy of SUBARU OF AMERICA, INC.
  5. Disconnect airbag module connector on back of airbag module.
  6. Remove horn switch from steering wheel as shown.
    Fig 2: Locating Horn Switch From Steering Wheel
    G04991873Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect horn and cruise control command switch connector, then remove cruise control command switch.
    Fig 3: Identifying Cruise Control Command Switch Connector
    G04991874Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.