2006 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Cruise Control Command Switch: Inspection

WARNING: This page is about a different car, the 2006 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.

Measure cruise control command switch resistance.

Fig 1: Measuring Cruise Control Command Switch Resistance
G04991875Courtesy of SUBARU OF AMERICA, INC.

Check continuity between cruise control command switch terminals.

CRUISE CONTROL COMMAND SWITCH TERMINALS RESISTANCE SPECIFICATION

Switch Position Terminal No. Standard
CANCEL ON 1 (+) and 2 (-) Less than 1 Ω
ON 1 (+) and 3 (-) Less than 1 Ω
SET/COAST OFF 1 and 2 More than 1 MΩ
ON 1 and 2 Less than 1 Ω
RESUME/ACCEL OFF 1 and 3 More than 1 MΩ
ON 1 and 3 Less than 1 Ω

If NG, replace cruise control command switch.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.