2006 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Mode $01 (Current Powertrain Diagnostic Data)

Refer to data denoting the current operating condition of analog input/output, digital input/output or the powertrain system.

A list of the support data and PID (Parameter Identification) codes are shown in the following table.

LIST OF SUPPORT DATA AND PID (PARAMETER IDENTIFICATION) CODES

PID Data Unit of measure
01 Number of emission-related powertrain DTC and malfunction indicator light status ON/OFF
03 Fuel system control status -
04 Calculated engine load value %
05 Engine coolant temperature °C or °F
06 Short term fuel trim (Bank 1) %
07 Long term fuel trim (Bank 1) %
08 Short term fuel trim (Bank 2) %
09 Long term fuel trim (Bank 2) %
0B Intake manifold absolute pressure kPa
0C Engine revolution rpm
0D Vehicle speed km/h, MPH
0E Ignition timing advance °
0F Intake air temperature °C or °F
10 Air flow rate of manifold absolute pressure sensor g/sec
11 Throttle valve opening angle %
13 Check whether oxygen sensor is installed. -
15 Oxygen sensor output voltage (Bank 1 Sensor 2) V
15 Oxygen sensor compensation (Bank 1 Sensor 2) %
19 Oxygen sensor output voltage (Bank 2 Sensor 2) V
1C On-board diagnostic system -
24 Oxygen sensor output voltage and short term fuel trim associated with oxygen sensor (bank 1) V and %
28 Oxygen sensor output voltage and short term fuel trim associated with oxygen sensor (bank 2) V and %
34 A/F sensor lambda value (Bank 1 Sensor 1) -
34 A/F sensor current value (Bank 1 Sensor 1) mA
38 A/F sensor lambda value (Bank 2 Sensor 1) -
38 A/F sensor current value (Bank 2 Sensor 1) mA
NOTE: Refer to general scan tool manufacturer's instruction manual to access generic OBD-II PIDs (MODE $01).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.