Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Subaru Outback RFACTORY OEM SERVICE PROCEDURE
Drive Cycle E
- Make sure that the battery voltage is more than 10.9 V.
- Perform the Clear Memory Mode. < Ref. to CLEAR MEMORY MODE . >
- Drive the vehicle for the distance equal to the fuel of 30 l (7.9 US gal, 6.6 Imp gal).
NOTE:
- It is possible to drive intermittently.
- Do not disconnect the terminal of battery during diagnosis. (Data will be cleared when disconnecting the battery terminals.)
DTC CHART
| DTC | Item | On condition |
|---|---|---|
| P0461 | Fuel Level Sensor "A" Circuit Range/Performance | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.