2006 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

RH Side

  1. Remove the collector cover.
  2. Release the fuel pressure. < Ref. to RELEASING OF FUEL PRESSURE , PROCEDURE, Fuel. >
  3. Open the fuel filler flap lid, and remove the fuel filler cap.
  4. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G05019586
  5. Remove the air cleaner case. < Ref. to REMOVAL , Air Cleaner Case. >
  6. Remove the fuel pipe protector RH.
    Fig 2: Locating Fuel Pipe Protector RH Bolts
    G05018455
  7. Disconnect the connector from fuel injector.
    Fig 3: Locating Fuel Injector Connector
    G05018456
  8. Remove the engine harness from fuel injector pipe RH.
  9. Remove the bolt which holds fuel injector pipe onto intake manifold.
    Fig 4: Locating Bolts Holding Fuel Injector Pipe Onto Intake Manifold
    G05018411
  10. Remove the fuel injector while lifting up the fuel injector pipe.
Chapter Navigation
Return to Chapter: Removal
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.