2006 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

LH Side

  1. Remove the collector cover.
  2. Release the fuel pressure. < Ref. to RELEASING OF FUEL PRESSURE , PROCEDURE, Fuel. >
  3. Open the fuel filler flap lid, and remove the fuel filler cap.
  4. Remove the battery.
  5. Remove the generator harness from fuel pipe protector LH.
  6. Remove the fuel pipe protector LH.
    Fig 1: Locating Fuel Pipe Protector LH Bolts
    G05018408
  7. Disconnect the connector from fuel injector.
    Fig 2: Locating Fuel Injector Connector
    G05018459
  8. Remove the engine harness from fuel injector pipe LH.
  9. Remove the bolt which holds fuel injector pipe onto intake manifold.
    Fig 3: Locating Bolts Holding Fuel Injector Pipe Onto Intake Manifold
    G05018418
  10. Remove the fuel injector while lifting up the fuel injector pipe.
Chapter Navigation
Return to Chapter: Removal
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.