Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2006 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Front Oxygen (A/F) Sensor: Installation

Before installing front oxygen (A/F) sensor, apply anti-seize compound only to the threaded portion of front oxygen (A/F) sensor to make the next removal easier.
Anti-seize compound: NEVER-SEEZ NS-165 or the equivalent

CAUTION: Never apply anti-seize compound to the protector of front oxygen (A/F) sensor.
Install the front oxygen (A/F) sensor.
Tightening torque: 21 N.m (2.1 kgf-m, 15.2 ft-lb)
- LH side
  
  Fig 1: Locating Front Oxygen (A/F) Sensor (LH Side)
- RH side
  
  Fig 2: Locating Front Oxygen (A/F) Sensor (RH Side)
Connect the connector of front oxygen (A/F) sensor.
- LH side
  
  Fig 3: Locating Front Oxygen (A/F) Sensor (LH Side)
- RH side
  
  Fig 4: Locating Front Oxygen (A/F) Sensor (RH Side)
Lower the vehicle.
Connect the battery ground cable to the battery.

Fig 5: Connecting Ground Cable To Battery

Chapter Navigation

Return to Chapter: Front Oxygen (A/F) Sensor

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.