Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Performance Test
The starter should be submitted to performance tests whenever it has been overhauled, to assure its satisfactory performance when installed on the engine.
Three performance tests, no-load test, load test, and lock test, are presented here; however, if the load test and lock test cannot be performed, carry out at least the no-load test.
For these performance tests, use the circuit shown in figure.
- No-load test
With switch on, adjust the variable resistance until the voltage is 11 V, read the value of ammeter to measure rotating speed. Compare these values with the standard.
No-load test (Standard):Â
Voltage/CurrentÂ
MT modelÂ
Max. 11 V/90 A or lessÂ
AT modelÂ
Max. 11 V/90 A or lessÂ
Rotating speedÂ
MT modelÂ
1,820 RPM or moreÂ
AT modelÂ
1,720 RPM or moreÂ
- Load test
Apply the specified braking torque to starter. The condition is satisfactory if the current draw and rotating speed are within specifications.
Load test (Standard):Â
Voltage/LoadÂ
MT modelÂ
8 V/7.76 N.m (0.79 kgf-m, 5.7 ft-lb)Â
AT modelÂ
8 V/12.78 N.m (1.30 kgf-m, 9.4 ft-lb)Â
Current/SpeedÂ
MT modelÂ
280 A/900 RPM or moreÂ
AT modelÂ
370 A/850 RPM or moreÂ
- Lock test
With the starter stalled, or not rotating, measure the torque developed and current draw when the voltage is adjusted to standard voltage.
Lock test (Standard):Â
Voltage/CurrentÂ
MT modelÂ
3 V/900 A or lessÂ
AT modelÂ
3 V/900 A or lessÂ
TorqueÂ
MT modelÂ
13.62 N.m (1.38 kgf-m, 10.0 ft-lb)Â
AT modelÂ
15.42 N.m (1.57 kgf-m, 11.3 ft-lb)Â
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
