Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2006 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Starting/Charging Systems (H4SO): Generator: Removal

Disconnect the ground cable from battery.

Fig 1: Disconnecting Ground Cable From Battery
Disconnect the connector and terminal from generator.
- 2.5 L Non-turbo model
  
  Fig 2: Identifying Generator Connector - 2.5 L Non-Turbo Model
- 3.0 L Non-turbo model
  
  Fig 3: Identifying Generator Connector - 3.0 L Non-Turbo Model
- Turbo model
  
  Fig 4: Identifying Generator Connector - Turbo Model
Remove the V-belt covers.
Remove the V-belts.
< Ref. to FRONT SIDE BELT (H4SO) , REMOVAL, V-belt. > or < Ref. to FRONT SIDE BELT (H4DOTC) , REMOVAL, V-belt. > < Ref. to REMOVAL , V-belt. >
Remove the bolts which install the generator onto bracket.

Fig 5: Locating Generator Bolts

Chapter Navigation

Return to Chapter: Generator

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.