2006 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Steering Angle Sensor: Replacement

CAUTION:
  • Do not perform the removal except when the replacement.
  • When replacing more than three times, replace the combination switch as assembly to protect the threads.
  1. Set the steering wheel in a straight-ahead position.
  2. Disconnect the ground cable from battery.
  3. Remove the airbag module.

    < Ref. to REMOVAL , Driver's Airbag Module. >

    WARNING: Always refer to "Airbag System" when performing the airbag module repair service. < Ref. to CAUTION , General Description. >
  4. Remove the steering wheel.

    < Ref. to REMOVAL , Steering Wheel. >

  5. Remove the screws and remove the steering column lower cover.
  6. Remove the two screws securing the steering column upper cover.
  7. Unlock the harness band and disconnect the connector of the steering angle sensor.
    Fig 1: Disconnecting Connector Of Steering Angle Sensor
    G05020273
  8. Remove the screws which secure the roll connector to steering column.
    Fig 2: Locating Steering Column Screws
    G05020274
  9. Remove the steering angle sensor from roll connector.
    Fig 3: Locating Steering Angle Sensor Screws
    G05003591
  10. Turn the protrusion portion of new steering angle sensor to match the alignment mark of inspection hole.
    Fig 4: Identifying Alignment Mark Of Inspection Hole
    G05020276
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.