Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Subaru Outback F4-2.5L SOHCFACTORY OEM SERVICE PROCEDURE
System Specifications
SPECIFICATIONS
Crank Pulley 44 Nm (4.5 kgf-m, 33 ft. lbs.)
Tighten the crank pulley bolt keeping them in an angle between 65° and 75°.
Timing Cover
Tightening torque 5 Nm (0.5 kgf-m, 3.6 ft. lbs.)
Crank Pulley 44 Nm (4.5 kgf-m, 33 ft. lbs.)
Tighten the crank pulley bolt keeping them in an angle between 65° and 75°.
Timing Cover
Tightening torque 5 Nm (0.5 kgf-m, 3.6 ft. lbs.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.